[over9k] used his Arduino to set up a laser trip wire. The laser is mounted along side the Arduino, reflects off of a mirror, and shines on a photoresistor that interfaces via a voltage divider. The ...

Arduino test code is run to see if the sensors are working properly, with built-in LED flashing when the sensor is triggered, and turning off when the sensor is released. The testing of the keys ...

Abstract: To provide efficient and prompt CPR treatment during medical emergencies, this research paper describes the development of an Arduino based CPR model. The created automated CPR model uses ...

Abstract: For several years, the reconstruction of Computer Aided Design (CAD) models from a deformed mesh get more and more attention. This CAD model is used in order to visualize 3D objects that ...

We present a novel generative model for Computer Aided Design (CAD) that 1) represents high-level design concepts of a CAD model as a three-level hierarchical tree of neural codes, from global part ...

We compare our multi-agent architecture MEDA with recent state-of-the-art CAD generation framework CADCodeVerify across three CAD evaluation metrics and compilation rate as shown in the table below.

In our software overview you will find a range of different programs that are necessary for 3D printing. Here we summarize the most important CAD-programs for 3D models. 3D CAD software enables the ...

PicoIDE is an open-source hardware IDE/ATAPI drive emulator based on a Raspberry Pi RP2350 board and designed to replace hard drives and CD-ROM drives in vintage computers with microSD card storage.