Hosted on MSN
Build a simple Arduino-based DCC system
This article will help you build a simple Arduino-based DCC system. Growing up in the 1980s I was living the dream. I had an HO layout on a 4 x 8 sheet of plywood in my parents' basement in Reading, ...
At about $30, the Arduino isn't an expensive device, but if you want to make your own, simpler version, electronics blog Hardware Startup shows off how to build an Arduino clone for less than $5.
Electrical power systems engineers need practical methods for predicting solar output power under varying environmental conditions of a single panel. By integrating an Arduino-based real-time data ...
AC loads are everywhere around us because at least home appliances are supplied with the mains power. Therefore, we always face the situations that we want to have full control (dimming) over an AC ...
Since you lacked the USB interface in your own Arduino board, it becomes necessary to use a homemade/ready-made USB to Serial Converter Module as an efficient and economical solution. Inexpensive and ...
One of the easiest tricks to keeping a house warm (or cool), is to open and close the blinds in time with the sun. Of course, that's only helpful if you're home all the time to do that. Instructables ...
The rise of low-cost, hacker-friendly electronics is fueling a new wave of hardware hobbyists. Using programmable boards like the Arduino and dirt-chip computers like the Raspberry Pi, you can build ...
All products featured on WIRED are independently selected by our editors. However, we may receive compensation from retailers and/or from purchases of products through these links. But Belgium startup ...
Results that may be inaccessible to you are currently showing.
Hide inaccessible results