The Arduino Esplora is a ready-to-use, easy-to-hold controller that lets you explore the infinite possibilities you have in the world of Arduino, without having to deal with breadboards or soldering.

Here’s a no-PCB Arduino that doesn’t obscure the DIP footprint of the AVR chip. It’s built on an ATmega88 chip, and includes a programming header, reset button, a couple of filtering caps, and an LED.

Arduino may be known for revolutionizing open source hardware platforms, but this week enters the 3D printer market with the small and (relatively) affordable Materia 101. Produced in partnership with ...

The Stickvise has been a staple of the Hackaday community for a while now. If you need something held for soldering there’s no better low-cost helping hand. But if you’re just using a breadboard and a ...

Microaware’s Sandwizz, a schematic-configurable breadboard, hit 120% of its funding goal on Kickstarter on July 19, 2024. The KiCad freeware schematic capture tool is used to configure an active ...

Before opening the Arduino software, wire up the Arduino according to the circuits page using the 8MHz minimalist breadboard circuit but with a 10k pull-up resistor on the reset pin (physical pin 1).