Stepper motors are useful for relatively low-speed, intermediate-torque drive and positioning applications, particularly where accurate sub-revolution rotor position control is necessary. Motors of ...

grbl is stepper motor controller firmware for three-axis cnc machines, intended to run on Arduinos with a motor driver add-on board. Engineer in Wonderland cnc-related blogs are indexed here It is the ...

The SLA7070MPRT series are unipolar two-phase stepper motor driver integrated circuits (ICs). This device uses a clock input method as a control signal input method, enabling full control of the ...

Rohm Semiconductor has developed an evaluation kit for motor driver devices which is designed as a ‘shield’ to plug directly into the Arduino open source board. There different versions of the kit for ...

Makers, developers and Arduino enthusiasts searching for silent stepper drivers with high resolution encoders which are also Arduino compatible. May be interested in the new range of uStepper S line ...

[Neumi] over on Hackaday.IO wanted a simple-to-use way to drive stepper motors, which could be quickly deployed in a wide variety of applications yet to be determined. The solution is named Ethersweep ...

ST Micro's Markus Ekler explains the technology and derives thermal loss equations that can be used to support design decisions for stepper motor driver circuits. One constant trend in the automotive ...

TRINAMIC Motion Control's new TMC2660 stepper motor driver IC supports motor drive currents up to 4A. The new IC integrates both a pre-driver for real-time calculation of motor coil current values, ...

[Dan] salvaged some parts from an old printer a while back and finally found some time to play with them. One of the things he was most interested in is the geared stepper motor seen above. He was ...

Adafruit has unveiled a new addition to their range of add-on boards with the launch of the new DC Motor and Stepper FeatherWing add-on board, which has been specifically designed for all Feather ...